Author: Site Editor Publish Time: 07-09-2022 Origin: Site
This is 3in 1 automatic OCA film machine, it built-in vacuum pump and air compressor. The Pressure Regulator back of machine is for control down suction plate, when adjust Pressure Regulator to big, the downside suction plate will be strong, up suction plate suction will be weak, in usually, we just adjust it to half, then lock it.
Operating steps:
1. First use the tape to seal the up and downside suction plate；
2. Put the glass on down suction plate edge position, Let Machine roller can cover the edge of glass, then use pen make a mark, for next operation can find the same place.
3. under the glass cover place, use Sharp stuff make one hole between two holes；
4. OCA must alignment the wheel, Roller must be pressed on to the edges of OCA, The cover place of up plate by OCA, use the sharp stuff make holes completely；
5. plug the powerline, turn on the Power switch；
6. put the glass to the same place as marked, turn on the vacuum switch, clean the glass；
7. tear off the protect film of OCA, turnoff the vacuum switch；
8. Press the up suction plate on down suction plate, Turn on the vacuum switch；
9. When OCA be suction, Lift the up suction plate, Then tear off another protect film of OCA；
10. press the up suction plate to under suction plate again, turn on the start button, after that turnoff start button, whole process finished.
English
